Warning: if both SetUp and Core are new,
you must first update the SetUp ROM before updating the FPGA Core!

Use the SetUp Flasher utility first, then go into this freshly updated SetUp (hold Reset for 1.5 sec) and select "Load SetUp defaults + restart" (CapsShift+L) 

Next run the ElCoreUp.tap (ELCOREUP.BAS) to update the FPGA Core.


Flash (SetUp) utility for the eLeMeNt ZX computer
-------------------------------------------------
Check the version of your eLeMeNt ZX motherboard. FlashSetUp_v2.tap (FLSETUP2.BAS) is intended for V2 motherboards. You can select an Area for the update (default Area is 0). FlashSetUp_v1.tap (FLSETUP1.BAS) is intended for V1 motherboards. You cannot select an Area for the update by a software way on the board V1, use hardware DIP-switches on the motherboard instead.

FlashSetUp_v1.tap (FLSETUP1.BAS) uses flash5 binary, FlashSetUp_v2.tap (FLSETUP2.BAS) uses flash6 binary.

There is also a standalone program to check your settings or change the configuration, named Setup.tap, ELSETUP.


Flasher (Boot, SetUp, esxDOS etc.) utility for the MB03+ Ultimate interface
---------------------------------------------------------------------------
Run the flash utility called Reflashr.tap (REFLASHR.BAS). Press the asterisk '*' to flash all ROM slots of the MB03+. Unlike the eLeMeNt ZX, in the MB03+ some ROMs are usually updated together, especially Boot and SetUp are interdependent (also the WIFI ROM can be subject to frequent updates).

This utility also allows you to update individual CustomROMs (BASIC and Game ROMs) separately.

There is a standalone program to check your settings or change the configuration, named Setup.tap, MBSETUP.


FPGA Core update utility
------------------------
The CORE update utility (ElCoreUp.tap, ELCOREUP.BAS) is since version 1.4 common to both MB03+ and eLeMeNt ZX  and can detect and handle different types of FPGAs (Spartan7 of the MB03+ and Artix7 modules AU and AU+ of the eLeMeNt ZX).

If you are using MB03+ connected to the eLeMeNt ZX, you can select either one of devices or use an autodetection - if the the MB03+ is detected, the utility will load a new core into it.

version 1.7
- minor improvements

version 1.6
- MB03+ board version detection

version 1.5
- device menu selection

version 1.4
- MB03+ support

version 1.3
- text correction

version 1.2
- verify written data
- first public version

version 1.1
- detection type of board Au/Au+
- Au+ update added

version 1.0
- eLeMeNt and core detection
- detect flash type
- check flash file
- parsering bitstream
- programing flash




